Learning transponder(s) WAECO / Dometic 921T immobiliser (GB)

Gemaakt door Erwin Derks, Gewijzigd op Do, 25 Mei, 2023 om 2:42 PM op Erwin Derks

Date created: 25-05-2023

Document revision: A

Product/brand:	WAECO / Dometic	Vehicle brand:	all
Product type:	921T	Vehicle type:	all.
Product hardware version:	all	Model year:	all.
Product software version:	all	Model code:	all.

Learning procedure new TRANSPONDER(s)

Needed:

Vehicle + ignition key

921T / working transponder or working pincode.

New transponders

Pen + paper

1) Immobiliser has to active (LED flashing)

2) Turn ignition ON.

3) Apply a working transponder to the antenna ring.

4) While holding the transponder to the antenna ring => turn the ignition OFF

5) Remove the transponder from the antenna ring.

6) The LED will light up constant (start learning procedure).

7) Apply the new transponder onto the antenna ring.

8) The LED goes dark shortly to indicate the new transponder is recognised.

9) Repeat step 8 and 9 for every new transponder and always finish the procedure by learning the one transponder who has started the learning procedure.

10) When the last transponder is learned, wait (10 seconds) for the LED to flash pincode

Note.write down the pincode and handover to customer

After the pincode the procedure is ended.

Check all transponders for proper operation

Old / lost transponders are deleted from the system.